DNF Controls GTP-32BP Installation Rev 3-1 User Manual
Gtp-32 breakout panel installation instructions
Page 1 of 2
GTP-32 BREAKOUT PANEL
INSTALLATION INSTRUCTIONS
Revision 012511
A. CONNECTING THE GTP-32 UNIT TO THE BREAKOUT PANEL.
Look at the back of the GTP-32 unit and note the legend under the 37 pin I/O
connectors. The breakout panel has two sets of 37 pin connectors, one set is labeled
GPI & GPO and the other set is labeled GPIO. Connect the furnished 37 pin interconnect
cable to the matching connector on the breakout panel and the GTP-32 unit. Connect
all 4 cables to their respective connectors.
Example 1:
Legend on GTP-32 unit = GPOI 1-8; connect to GPOI 1-8 connector on breakout panel.
Legend on GTP-32 unit = GPOI 9-16; connect to GPOI 9-16 connector on breakout
panel
Legend on GTP-32 unit = GPOI 17-24; connect to GPOI 17-24 connector on breakout
panel.
Legend on GTP-32 unit = GPOI 25-32; connect to GPOI 25-32 connector on breakout
panel
Example 2:
Legend on GTP-32 unit = GPI 1-16; connect to GPI 1-16 connector on breakout panel.
Legend on GTP-32 unit = GPI 17-32; connect to GPI 17-32 connector on breakout panel
Legend on GTP-32 unit = GPO 1-16; connect to GPO 1-16 connector on breakout panel.
Legend on GTP-32 unit = GPO 17-32; connect to GPO 17-32 connector on breakout
panel
12843 Foothill Blvd. Suite C
Sylmar, California 91342
V: 818.898.3380
F: 818.898.3360