DNF Controls CP20 - Manual (Page 26)

Flex Control Network ® , CP20 User Manual Page 22 of 42
5.
A.
B.
C.
VTR mode
NOTE: TAPE MUST BE LOADED MANUALLY ON THE VTR.
Play
1) OPTIONAL:
a. Set an IN Point and OUT Point.
b. Jog/Shuttle to the desired IN point. Press [IN].
c. Jog/Shuttle to the desired OUT point. Press [OUT].
OR
d. Press [SHIFT] + [IN]. Manually enter the IN time on the numeric
keypad. Press [ENTER].
e. Press [SHIFT] + [OUT]. Manually enter the OUT time on the numeric
keypad. Press [ENTER].
2) Press [PLAY]. The tape will play from its current time to the OUT point, and
then stop. If OUT point is not set then it will play to end of TAPE.
Recue
Press [GOTO]. The tape will cue to the IN point. If no in point is entered: will
do nothing.
Mark a Cue point
NOTE: TAPE MUST BE LOADED MANUALLY ON THE VTR.
With menu setting: MARK CUE=MARK.
1) Press VTR [1], [2], [3], [4], [5], [6], [7] or [8].
2) OPTIONAL
a. Use the transport functions to view the clip.
b. Press [IN] to set an IN point. The IN LED will turn on.
c. Press [OUT] to set an OUT point. The OUT LED will turn on.
d. To delete an IN or OUT point, press and hold [DEL], then press [IN]
or [OUT]. The IN/OUT LED will turn off.
e. If no IN point is set, the current location of the clip will be SET as the
IN point.
3) Select the desired Cue Point by pressing [NEXT], [LAST] or by manually
entering the Cue Point using the numeric keypad, followed by [ENTER].
The selected Cue Point number is shown on the bottom part of the display.
4) Press [MARK] to create the Cue point.
NOTE: MARK will overwrite the previous contents of the Cue Point.
5) Press [ESC] at anytime to escape without MARKing.