DNF Controls CP20 - Manual (Page 22)

Flex Control Network ® , CP20 User Manual Page 18 of 42
MARK CUE: {CURRENT}: The cue data will be saved in the current
cue point location.
{ADVANCE}: The cue point number will increment by
one and then the cue data will be saved in the cue point
number location.
MARK:
Select the TIME DATA to save into the cue point.
{IN and OUT}: Save IN and OUT points into the cue
point.
{CURRENT}: Save only the CURRENT time into the cue
point. Do NOT save the IN and OUT points in the cue
point.
MARK KEY:
{MARK}: To save only the time CURRENT into the cue
point
{LEARN}: To save IN/OUT points and GANG DATA into the
cue point.
(NOTE- Press SHIFT + MARK to execute the alternate
function)
LOAD KEY:
Select LOAD key mode-
{GOTO}: Only the SELECTED CHANNEL'S cue point
data will be loaded. This mode does NOT restore the
gang configuration.
{RECALL}: The cue point data will load on all channels
that were part of the original Learn. This mode will
restore the Learned gang configuration.
{REDIRECT}: Load the cue point data for Channels 1 and
2 on the selected channel pair- {1,2}, {3,4}, {5,6}, or
{7,8}. Follow the prompt on the LCD display.
(NOTE- Press SHIFT + LOAD to execute the alternate
function)
GANG:
Select GANG mode.
{TEMPORARY}: Gang Channels by pressing and
holding one [Channel] key, then press and release other
[Channel] keys to add to the gang. Release all
[Channel] keys when done. Press any [Channel] key to
cancel the gang.
{PERMANENT } : Press and hold [SHIFT] and then press
any [Channel] key. Release [SHIFT]. Follow the
prompts on the LCD display. Press a [Channel] key to
add it to the gang. Press the [Channel] key again to
remove it from the gang. Press [SHIFT] when done. The
gang will remain until cancelled by pressing [SHIFT] +
any [Channel] key.