DNF Controls CP20 - Manual (Page 31)

Flex Control Network ® , CP20 User Manual Page 27 of 42
6.
A.
B.
C.
CLIP mode
Load a clip
1) Select a VTR by pressing VTR [1], [2], [3], [4], [5], [6], [7] or [8].
2) Press [CLIP LIST] to view the list of CLIP IDs that are resident on the Video
Server. The CLIP LIST indicator will turn on. Turn the Wheel clockwise to
scroll forward, or counter-clockwise to scroll backward, through the list of
available CLIPs. Backward scrolling is limited to the last 10 screens of CLIP
IDs viewed.
OR
Manually enter a CLIP ID using the CP20 numeric keypad, or PC keyboard.
3) Press [LOAD] to load the entered CLIP ID for playout.
4) Repeat steps 1) thru 3) to load clips on other VTRs.
5) Set the Gang Mode, if required. See “GANG SETUP” in “FUNCTION TABLE”
section.
Play a clip
1) OPTIONAL:
a. Set an IN Point and OUT Point.
b. Jog/Shuttle to the desired IN point. Press [IN].
c. Jog/Shuttle to the desired OUT point. Press [OUT].
OR
d.
Press [SHIFT] + [IN]. Manually enter the IN time on the
numeric keypad. Press [ENTER].
e. Press [SHIFT] + [OUT]. Manually enter the OUT time on the
numeric keypad. Press [ENTER].Press [PLAY]. The clip will
play from its current time to the OUT point, and then stop. If
OUT point is not set then it will play to end of clip.
2) Press [PLAY], the clip will play from its current position to the out point, and
then stop. If out point is not set, then play to the end of the clip.
Recue
Press [GOTO]. The clip will cue to the IN point. If no IN point is set then cue to
beginning of clip.