Digi CM - Manual (Page 95)

Power Controller
Chapter 12 95
Outlet Configuration
The following procedure allows you to setup the power supplied to your device
from the power controller.
1. From Power controller, click Outlets .
2. Click the outlet number to configure.
3. Select the serial port number that controls the device connected to the Digi
CM (if any). If the port number has a title, it will appear.
Note: If you want to add a title or change the existing title, go to Serial port >
Configuration and select the port number that you want to add or change the title.
Enter the title and click
Save & apply . Go back to Power Controller > Configuration
> Title > Outlets and select the outlet you are configuring to continue.
4. If you are not selecting a serial port number, you can modify a user’s
access on this screen. Enter the User Access Control parameters - see
"User Access for Power Controller" on page 96.
5. Click Save to flash and repeat steps 2- 4 for each outlet you want to
configure.
6. Click Save & apply .