Digi CM - Manual (Page 52)

Configuring SMTP Alerts
52 Chapter 5
Configuring SMTP Alerts
Most SMTP servers check the sender’s email address with the host domain
name to verify the address as authentic. Consequently, when assigning an
email address for the device email address, any arbitrary username with the
registered hostname may be used. An example is [email protected].
To configure the Digi CM for SMTP alerts, the following parameters are required:
SMTP server - Use either the hostname or the IP address.
Device mail address - Specify the sender’s email address for the log and
alarm delivery.
SMTP mode - Specify the type of SMTP server to use.
Username and password - These fields are required for POP before SMTP
and SMTP with authentication servers.
To configure SMTP alerts on the Digi CM, do the following:
1. Access the web interface.
2. Under the Network heading, choose SMTP configuration.
3. Fill in the required fields. SMTP with authentication and POP before SMTP
require usernames and passwords.
4. Click Save & apply .
SNMP Information
Applications such as NMS (Network Management System) or an SNMP
browser can exchange information with the Digi CM and control actions to the
unit. The protocol functions defined for SNMP includes GET, SET, GET-Next,
GET-Bulk, and TRAP. Below are the definitions of the protocol functions found
in SNMP. Authentication, power on, and link up traps are supported.
.
The Digi CM
supports SNMP
authentication,
power on, and
link up traps.
Protocol Function
GET Queries a device for more information
SET Makes changes to a device’s state
GET-Next After an initial GET query, goes to the next value
GET-Bulk Retrieves tables of information and security functions
TRAP Notifies a system administrator of a significant event