Digi CM - Manual (Page 93)

Power Controller
Chapter 12 93
Add the power controller
1. Log in to the Digi CM (username root, password dbps).
2. Click Power Controller > Configuration.
3. Select the port number of the serial port you want have connected to the
power controller(s), the manufacturer of the power controller, and the
number of units to be cascaded (1 means that one unit will be connected
(no cascading)).
Note: The number of cascaded units cannot be changed later, so make sure you have
all power controllers connected before proceeding.
The default title is the manufacturer brand and the port number it is
connected to. You have the ability to change this title in step 5 if needed.
4. Click Add controller .
5. After the controller is detected automatically, you can correct the number of
ports if necessary or edit the port title.
6. Click Save & apply .
7. Continue by setting the alarms and tresholds.