Digi CM - Manual (Page 116)

Setting Date and Time
116 Chapter 14
Setting Date and Time
The Digi CM provides two options for keeping system time. The first is by
using an NTP server and the other is through an internal battery backup. To
configure the Digi CM for date and time, do the following:
1. Access the web interface.
2. System administration > Date and time.
3. To use an NTP server, choose Enable, the NTP server’s IP address, the
Time offset, and the Date and Time fields.
or
To use the internal battery, fill in the Date and Time fields only.
Note: If you change your time zone, you must go back and reconfigure your time for the
time zone change to be effective.
4. Choose Save & apply .
Configuring a Host Name
The system administrator can assign a Host name to the Digi CM. This is often
helpful for administration purposes to locate a specific Digi CM on the network.
To assign the Digi CM a device name, do the following:
1. Access the web interface.
2. System administration > Device name.
3. Enter the name you want to assign the Digi CM.
4. Choose Save & apply .