Base modem image, Enable redundancy, Codecast address – Comtech EF Data CDM-570/L Vipersat Parameter Editor User Manual
Page 82: Event logging, Enable, Level, Automatically save param after config change, Change -66
Maintenance
2-66
CDM-570/L, CDD-56X Parameter Editor User Guide
• Image 2
Base Modem Image
The radio button options available in the Base Modem Image determine which
image will be used to boot from following a reset of the modem unit.
Enable Redundancy
When a Remote modem is in a 1:1 redundant configuration, this parameter will
be Enabled (checked), and ParamEditor can be used to change this setting to
Disable redundancy (unchecked) for the modem.
Caution: ParamEditor can not be used to Enable Redundancy—it can only
Disable it when it has been Enabled. Once this parameter is Disabled
and the configuration is saved, this parameter will become inactive
(grayed out).
Codecast Address
Enter the multicast address to be used by the modem/router to receive Codecast
messages in this field.
Event Logging
Enable
Selecting the Enable box will enable event logging on the modem/router.
Level
The radio buttons available in the Level box allow selecting the type of data to
be logged:
• Errors only
• Errors and Warnings
• All information
Automatically Save PARAM After CONFIG Change
This parameter is not supported in Vipersat networks, and will appear grayed
out (inactive). Refer to the modem’s user documentation for additional informa-
tion on this setting.