Protocol, Figure 2-11 add qos rule, max/priority mode 2-15 – Comtech EF Data CDM-570/L Vipersat Parameter Editor User Manual
Page 31
Chapter
2 -
Using Parameter Editor
2-15
Network
Figure 2-11 Add QoS Rule, Max/Priority Mode
Selecting the QoS Switching check box at the bottom of the dialog enables
entry of values into the Type, Data Rate, and Timeout fields to be used to
determine when a switch will occur.
Note: This parameter will not be active/selectable unless the modem is a
Remote and Automatic Switching is enabled. QoS Application Switching
must be enabled also for QoS switching to occur. See the section
In each of these modes, there exists a Default rule at the top of the table that is
preconfigured and can not be removed. This rule can be modified, but the only
active parameter is Enable Filtering.
Protocol
Clicking the Protocol drop-down menu displays the available protocols. Select
the appropriate protocol from the list, as shown in figure 2-12.
When selecting a protocol for a QoS Rule, be aware that the modem/router
allows a very broad selection (such as IP) or a very specific protocol. For exam-
ple, RTP traffic can consist of UDP portion (for voice or video) and a TCP
portion (for RTP signaling). These could have separate QoS Rules created or all
be included in a single Rule by selecting RTP as the protocol.
NOTE