Comtech EF Data CDM-570/L Vipersat Parameter Editor - Manual (Page 56)

Vipersat
2-40 CDM-570/L, CDD-56X Parameter Editor User Guide
modem that will be required to send switching requests to the VMS in response
to either traffic type (Application switching) or network traffic loads (Load
switching).
Use the Enable Automatic Switching check box to enable/disable the Auto-
matic Switching feature for this modem.
Figure 2-27 Switching dialog
Application Switch Detection
Application switching can be enabled for Video, Voice, Quality of Service
(QoS), and/or Type of Service (ToS) by selecting the appropriate check box in
the Application Switch Detection dialog (figure 2-28). Application switching
controls are only available on units configured as remotes.
Note: Load switching by VMS is not affected by this setting.
Application switching is capable of changing the bandwidth used, but the
change is determined entirely by the type of application being requested while
ignoring load requirements.
NOTE