Comtech EF Data CDM-570/L Vipersat Parameter Editor - Manual (Page 30)

Network
2-14 CDM-570/L, CDD-56X Parameter Editor User Guide
k. ORCL – ORACLE Protocol
l. CTRX – CITRIX Protocol
m. SAP
– Service Announcement Protocol
n. UDP – User Datagram Protocol
o. TCP
– Transmission Control Protocol
p. ICMP – Internet Control Message Protocol
q. IP
– All Internet Protocol
r. N-IP – All Non-Internet Protocol
2. By Source IP Address or Subnet.
3. By Destination IP Address or Subnet.
4. By Source Port (lowest port number first).
5. By Destination Port (lowest port number first).
The modem/router will sort each QoS rule as they are added, and the QoS Rules
Table will be updated to reflect the order with which rules are matched.
Rule Max/Priority & Rule Min/Max Modes
The Rule Max/Priority mode and the Rule Min/Max mode are very similar in
configuration. As the names imply, Rule Max/Priority is primarily based on the
Priority parameter and the Maximum Bandwidth parameter (the Minimum
Bandwidth parameter is not active), while Rule Min/Max is primarily based on
the Minimum and Maximum Bandwidth parameters (the Priority parameter is
not active).
Select the Rule mode radio button in the QoS dialog, then click on the Add...
button to open the Add QoS Rule dialog. Alternatively, select an existing rule
from the table and click on the Modify button to open the modify version of the
same dialog.
Note that there are All check boxes to the right of the IP addresses, Ports, and
Bandwidth fields. When an All box is checked, any range of values is accepted,
and the specific parameter fields are inactivated. Unchecking an All box, as
shown in figure 2-11, activates the fields for that parameter and allows the
values to be edited.