Enable snmp for modem configuration, Enable authentication trap, Trap version – Comtech EF Data CDM-570/L Vipersat Parameter Editor User Manual
Page 73: Enable authentication trap -57 trap version -57, Figure 2-40 snmp dialog -57
Chapter
2 -
Using Parameter Editor
2-57
Admin
Figure 2-40 SNMP dialog
Enable SNMP for Modem Configuration
Selecting the Enable SNMP for Modem Config box, shown in figure 2-40,
enables SNMP on this modem/router.
Tip: The VMS does not use SNMP management messages. Only enable this
function if other software exists on the network which uses this
information.
Enable Authentication Trap
Selecting the Enable Authentication Trap box determines whether a MIB2
authentication trap will be sent when a protocol data unit (PDU) with an invalid
community string is encountered. A community string is invalid when it does
not match the Admin, the Read Write, or the Read Only community strings.
Trap Version
Select either SNMP version 1 or SNMP version 2 using the radio button in the
Trap Version box.