Comtech EF Data DMD2401/DMD2401L - Manual (Page 93)

User Interfaces DMD2401/DMD2401L/DMD2401 IBS/IDR Satellite Modem
4-54 TM065 – Rev. 3.3
<1>
<2>
<1>
<1>
<1>
<1>
Remote AUPC
Status
Remote AUPC
Eb/No
Daughter Card
Fault
Transmit IDR
Backward Alarms
Control Mode
Drop Alarm
Status
Drop Backward
Alarm Status
Bit 0 = AUPC Communication Error
Bits 1-2 = Eb/No Status
0 = Eb/No is Invalid
1 = Eb/No is Valid
2 = Eb/No is Smaller Than Indicated Value
3 = Eb/No is Larger Than Indicated Value
Unsigned Binary Value Decimal Point Implied
Note: The following byte applies only if an asynchronous
interface card, IDR or IBS interface card is installed, and
the AUPC option is installed and the AUPC is enabled. If
not, ignore this byte.
0 = Daughter Card OK
1 = Daughter Card Faulted
The following byte applies only if an IDR or IBS interface
card is installed and the modem is in IDR mode. If not,
ignore this byte.
Bit 0 = Backward Alarm 1
Bit 1 = Backward Alarm 2
Bit 2 = Backward Alarm 3
Bit 3 = Backward Alarm 4
Bits 4 – 7 = Spare
(0 = Not Transmitted, 1 = Transmitted)
0 = Front Panel, 1 = Terminal, 2 = Computer
Bit 0 = Terrestrial Frame Lock Fault (all modes)
Bit 1 = Terrestrial Multiframe Lock Fault (PCM-30 and
PCM-30C only)
Bit 2 = Terrestrial CRC Lock Fault (PCM-30C and PCM-31C
only)
Bit 3 = Terrestrial Yellow Alarm Received (T1 only)
Bit 4 = Terrestrial FAS Alarm Received (E1 only)
Bit 5 = Terrestrial MFAS Alarm Received (PCM-30 and PCM-
30C only)
Bit 6 = Loss of T4errestrial Signaling (reported by DSP)
Bit 7 = Spare
Bit 0 = Backward Alarm Received from Drop Terrestrial
Bits 2 – 7 = Spares
Opcode: <240Bh>
Query a Modulator’s Status
Query Response
<1>
<1>
Revision Number
Alarm 1 Major
Alarm
Decimal Point Implied
Bit 0 = Transmit Processor Fault
Bit 1 = Transmit Output Power Level Fault
Bit 2 = Transmit Oversample PLL Lock Fault
Bit 3 = Composite Clock PLL Lock Fault
Bit 4 = IF Synthesizer Lock Fault
Bit 5 = Transmit FPGA Configuration Alarm Fault