Comtech EF Data DMD2401/DMD2401L - Manual (Page 114)

DMD2401/DMD2401L/DMD2401 IBS/IDR Satellite Modem User Interfaces
TM065 - Rev. 3.3 4-75
<1>
<1>
<1>
<1>
<1>
<1>
<1>
<1>
<1>
Exponent
Offset Frequency
Sign
BER/EbNo Status
Buffer Percent
Full
Input Level
Input Level State
Alarm 5
Insert Alarms
Insert Back
Alarm
AGC Voltage
0 = Offset Frequency Pos, 1 = Offset Frequency Neg
Bit 0 = Raw BER and Corrected BER Status (1 = Valid)
Bit 1 = Test 2047 BER Status (1 = Valid)
Bits 2 - 3 = EbNo Status (0 = EbNo is Invalid, 1 = EbNo is
Valid, 2 = EbNo is Smaller Than Indicated Value,
3 = EbNo is Greater Than Indicated Value
Bits 4 - 7 = Reserved
Unsigned Binary Value Representing % Buffer Full (0 - 100 in
1% Steps)
Unsigned Binary Value in -1 dB Steps, Negative Sign Implied
Signed Binary (0 = Equal to, 1 = Greater Than, -1 = Less Than
Value in -1 dB Steps, Negative Sign Implied
Bit 0 = IBS Satellite Multiframe Loss
Bit 1 = IBS Satellite Frame Loss
Bit 2 = Spare
Bit 3 = IBS Alarm if BER < 10
-03
Bit 4 = IBS Prompt Alarm
Bit 5 = IBS Service Alarm
Bits 6 - 7 = Spares
Bit 0 = Frame Lock Fault
Bit 1 = Multiframe Lock Fault
Bit 2 = CRC Lock Fault. Valid only in T1-ESF and E1 – CRC
enabled
Bit 3 = T1 Yellow Alarm Received
Bit 4 = E1 FAS Alarm Received
Bit 5 = E1 MFAS Alarm Received
Bit 6 = E1 CRC Alarm Received
Bit 7 = CRC Calculation Fault
Bit 0 = Backward Alarm Received from Satellite
Bits 2 – 7 = Spares
In Hex, decimal point implied.
Opcode: <240Ch>
Query a Demodulator’s Status
Query response
<1>
<1>
Revision Number
Alarm 1
Decimal Point Implied
Bit 0 = Receive Processor Fault
Bit 1 = Signal Lock Fault
Bit 2 = Receive Satellite AIS Fault
Bit 3 = Rx AGC/Input Level Fault
Bit 4 = Reed-Solomon Sync Fault
Bit 5 = Reed-Solomon Excessive Errors Fault
Bit 6 = Reed-Solomon Uncorrectable Word Fault
Bit 7 = Receive Forced Alarm
(0 = Pass, 1 = Fail)