Comtech EF Data DMD2401/DMD2401L User Manual
Page 61
User Interfaces
DMD2401/DMD2401L/DMD2401 IBS/IDR Satellite Modem
4-22
TM065 – Rev. 3.3
DaughterCPLD:
{F0XXXXNN, Not Present}
Indicates whether the firmware is present.
M&C (menu):
Term Baud:
{300 - 115200}
Indicates the Terminal Baud Rate.
Emulation:
{VT100, ADDS-VP, WYSE 50}
Allows the user to select the Terminal Emulation Mode
for the Terminal Port.
Remote Mode:
{RS-485, RS-232}
Allows the user to select the Remote Port Emulation
Mode.
Remote Addr:
{32 - 255}
Allows the user to select the Remote Port Multidrop
Address.
Remote Baud:
{300, 600, 1200, 2400, 4800, 9600, 19200}
Allows the user to select Remote Port Baud Rate
4.2.8 Test Menu Options and Parameters
2047 Test:
{None, Tx, Rx, Tx/Rx}
Allows the user to enable/disable the 2047 Pattern Test.
Tx enables the Transmit Pattern Generator.
Rx enables the Receive Pattern Generator.
Tx/Rx enables both.
Tx Ins Error:
{0000 - 9999}
Allows the user to select the number of errors to insert.
Once the number of errors to insert has been selected,
pushing ‘Enter’ causes the number of errors shown to be
inserted in the data stream.
Rx 2047 Err:
{No Sync, nnnnn}
Shows the number of errors detected by the 2047
pattern checker.
Rx 2047 BER:
{No Sync, nnnn x 10
-9
}
Shows the measured BER for the 2047 pattern.
Clear 2047:
(Ent = Y, Clr = N)
Restarts the 2047 BER Test.