Comtech EF Data DMD2401/DMD2401L - Manual (Page 101)

User Interfaces DMD2401/DMD2401L/DMD2401 IBS/IDR Satellite Modem
4-62 TM065 – Rev. 3.3
<2>
<1>
<1>
<1>
<1>
<1>
AUPC Default
Power Level
Daughter Card
Fault Mask
Transmit Mode
Transmit IDR
Overhead Mode
IDR Backward
Alarm Mask
IDR Force
Backward Alarm
1
Note: AUPC minimum power level < AUPC default power
level < AUPC max. power level.
Signed value, –50 dBm to –300 (–5.0 to –30 dBm), Implied
Decimal Point
Note: The following byte applies only if an IDR OR IBS
interface card is installed. If not, set to zero.
0 = Mask, 1 = Allow
Note: The following byte applies only if an IDR OR IBS
interface card is installed. If not, set to zero.
0 = Closed Net Mode
1 = IDR Mode
2 = IBS Mode
3 = Drop & Insert Mode
Note: The following byte applies only if an IDR OR IBS
interface card is installed, and the transmit mode
parameter is set to IDR Mode. If an IDR OR IBS interface
card is not installed, set to zero. If an IDR OR IBS
interface card is installed, but the transmit mode
parameter is not set to IDR mode, these bytes can be set
to any valid values, but will be ignored.
0 = Voice
1 = 64 Kbit Data
Note: The following byte applies only if an IDR OR IBS
interface card is installed, and the transmit mode
parameter is set to IDR Mode. If an IDR OR IBS interface
card is not installed, set to zero. If an IDR OR IBS
interface card is installed, but the transmit mode
parameter is not set to IDR mode, these bytes can be set
to any valid values, but will be ignored.
Bit 0 = IDR Backward Alarm 1
Bit 1 = IDR Backward Alarm 2
Bit 2 = IDR Backward Alarm 3
Bit 3 = IDR Backward Alarm 4
Bit 4 – 7 = Spare
(0 = Mask, 1 = Allow)
Note: The following byte applies only if an IDR OR IBS
interface card is installed, and the transmit mode
parameter is set to IDR Mode. If an IDR OR IBS interface
card is not installed, set to zero. If an IDR OR IBS
interface card is installed, but the transmit mode
parameter is not set to IDR mode, these bytes can be set
to any valid values, but will be ignored.
0 = Force Alarm Always ON
1 = Force Alarm Always OFF
2 = Normal Operation