Paxar Monarch 9850 - Manual (Page 216)

790Wait until the printer is idle (no batch waiting to print or
not receiving data) before you send any packets. This
error may occur when you try to print a test label if the
printer is busy.
791 The printer has an error pending. Turn off the printer.
Wait 15 seconds and turn it back on. Resend the
packets. If the problem continues, call Technical
Support.
792 The printer is not initialized. Call Technical Support.
793 The printer job queue is full. Turn off the printer. Wait
15 seconds and turn it back on. Resend the packets. If
the problem continues, call Technical Support.
794 The backfeed mode is not set.
795 Print engine lock-up. Call Technical Support.
850Invalid script packet or not enough flash memory for the
script. The script download failed. Format flash
memory and download the script using the COPY
command from DOS or the ADK2 software.
851 Invalid lookup table or not enough flash memory for the
script. The lookup table download failed. Check the
data in the lookup table. Format flash memory and
download the script using the COPY command from
DOS or the ADK2 software.
852 Invalid buffer definition packet or not enough flash
memory for the script. One or more of the following
buffers were invalid: input buffer, temporary buffer,
lookup buffer, printer, or array buffer. Check the buffer
definitions. Format flash memory and download the
script using the COPY command from DOS or the ADK2
software.
8-26 Diagnostics and Errors