Paxar Monarch 9850 - Manual (Page 166)

Recommended Settings for optimal
performance with:
Description of cut mode operation Straight Edge Tags Edge Aperture Tags
Cut
Mode
Cut Before
first tag in
Batch?
Cut
Between
Tags?
Cut After
Batch?
Extended
backfeed
Overstrike
w/verifier
Extended
backfeed
Overstrike
w/verifier
0 No No No Yes Yes No No
1 Yes Yes Yes* Yes Yes Yes Yes
2 Yes
No
(Feeds strips)
Yes* Yes Yes No No
3 Yes Yes Yes** No Yes Yes Yes
4 No Yes Yes* Yes Yes No Yes
5 Yes
No
(Feeds strips)
Yes** Yes Yes No No
* The last tag in the batch is queued to be cut once it reaches the knife; however, there
may be printed tags left between the printhead and the knife. The user must press
Feed/Cut or send another batch to feed the last tag out far enough to be cut. Enabling
extended backfeed eliminates printed tags between the knife and printhead.
** The printer feeds the last tag in the batch out far enough to be cut. No user intervention
is required to cut the last tag.
NOTE: The 9860 printer automatically backfeeds when
necessary. See "Defining the Backfeed Control
Packet" in Chapter 2 for more information. Do not use
extended backfeed when sensing on attacher-hole
supplies.
E7. cut_mult Number of tags to
print before cutting. A
cut multiple of one
cuts after each tag.
The range is 0 to
32,000. 0 is the
default.
The cut multiple is a
multiple of the print
quantity. If the cut
multiple is three and
the print quantity is
16, then five sets of
three tags and one
set of one tag is
produced.
NOTE: The last tag in the batch is always cut, regardless of
the multiple.
6-6 Printing