Paxar Monarch 9850 - Manual (Page 209)

575 The graphic included in your format could not be found.
Resend the graphic packet. If the error persists, call
Technical Support.
600 The printer could not image the batch, because the
batch was refused. Call Technical Support.
601 An error occurred while imaging the batch. Resend the
format, batch, font, and/or any graphic packets. If the
error persists, call Technical Support.
603 The batch was not found while imaging. Resend the
batch packet. If the error persists, call Technical
Support.
611 Font, bar code or density is invalid. The font, bar code
or density in the batch does not fit the format.
612 The data in this line of the batch is either missing or
does not match the format.
613 Reference point off tag.
614 Portion of field off tag. There may be an invalid
character in the packet. Make sure you did not enter O
for Ø.
615 Bar code width is greater than 16 inches or the number
of keywords for your PDF 417 bar code exceeds 928.
Decrease the density or shorten the amount of data to
print the bar code.
616 A bad dot falls on a bar code and the dot cannot be
shifted. A gray box is printed instead of the bar code.
However, 2D bar codes still print on the 9825/9850
printers when bad dots are present within the bar code
field.
618 Magnification must be 1 to 7 or 4 to 255 for the scalable
font.
619 The JIS (16-bit) code for Kanji is invalid.
Diagnostics and Errors 8-19