Paxar Monarch 9850 - Manual (Page 210)

620Font and printhead dot density mismatch. A 30 0 dpi
font is specified in the format, but a 203 dpi printhead is
used in the printer or vice-versa. Check the font or
change the printhead to correct the error.
621 An error occurred opening the TrueType font file. Select
a different font to download. If the error message
persists, call Technical Support.
622 Not enough memory to create the downloaded TrueType
characters in the scalable (vector) fonts buffer.
Reconfigure the printer’s memory and increase the
scalable fonts buffer. Resend the font, format, and
batch packet after reconfiguring the memory. If the
error message persists, call Technical Support.
M a c h i n e F a u l t s
These errors occur when there is a problem with the printer.
703 The printer sensed a calibration of different-sized black
marks. Make sure the correct supply is loaded.
704 Printer has not sensed a supply mark within the
specified number of inches or out of supplies.
Check the
✦ supply tracking
✦ supply marks
✦ black mark sensor position
✦ supply roll for binding.
Press ENTER or ESCAPE/CLEAR, depending on your
printer. If the error continues to appear, change the
supply.
710Band out of data. Call Technical Support.
711 UART receiving communication error (framing, parity,
etc.). Call Technical Support.
8-20 Diagnostics and Errors