Paxar Monarch 9850 - Manual (Page 170)

S p e c i a l P r i n t i n g C o n s i d e r a t i o n s
Keep in mind the following special printing considerations when
using a 985x or 9860 printer.
9 8 5 x P r i n t e r s
Print
Speed
Printing Printhead
Density
Knife Peel Mode Verifier
2.5/4.0/6.0 ips
direct
transfer
203/300 dpi supported supported supported
8.0 ips
direct
transfer
203/300 dpi not supported supported supported
10.0 ips
direct
transfer
203 dpi only not supported not supported supported
12.0 ips
direct
transfer
203 dpi only not supported not supported supported
* The minimum label feed length is 0.75 inches using 8, 10, or 12 ips printing. 94x5
emulation is not supported using 300 dpi. The maximum supply and image length with
the optional 300 dpi printhead is 12.0 inches (305 mm). The recommended print speed
using linerless supplies is 2.5 or 4.0 ips. Contact your Paxar Representative for supply
requirements in high temperature and high humidity environments.
9 8 5 5 R F I D P r i n t e r
The knife is not supported with RFID. The RFID printer pauses
while programming the RFID tag. For more information about the
RFID printer, see "RFID Considerations" in Chapter 3.
9 8 6 0 P r i n t e r
Print
Speed
Printing Printhead
Density
Knife Verifier
2.5/4.0/6.0 ips
direct
transfer
203/300 dpi supported supported
8.0 ips*
direct
transfer
203/300 dpi supported supported
* The 9860 printer allows cutting 1.2 inch feed length tags at 8.0 ips; however optimal cut
quality may not be achieved.
6-10 Printing