Paxar Monarch 9850 - Manual (Page 206)

409 The printer memory is full. Delete unnecessary formats
or graphics from memory. If you are using a graphic file
that is very large, consider using another mapping
method (such as run length encoding) to reduce the
required memory. To use flash memory, you must
format it first. See "Formatting Flash Memory" in
Chapter 2 for more information.
C o m m u n i c a t i o n F a i l u r e s
Errors 410 to 413 are usually caused by a hardware failure, by an
incorrect SETUP option or by the host ignoring flow control
(XON/OFF, CTS/RTS or DTR). Communication settings:
Baud rate 1200, 2400, 4800, 9600, 19200, 38400, 57600,
115200
Word length 7 or 8
Stop bits 1 or 2
Parity Odd, Even, None
Flow control None, XON/XOFF, DTR, CTS
410Parity on the printer does not match the parity on the
host. Check the parity setting under SETUP options.
411 Framing error. The printer cannot communicate with the
host. Make sure the host is turned on, communication
cables are connected correctly, port settings are correct,
and communications are active. Check the baud rate,
word length, and stop bits to make sure they match those
at the host. Do not toggle between Microsoft® Windows®
and MS-DOS, while using the COPY command, or you
will receive a framing error. Re-transmit the data.
412 There is a problem with flow control between the printer
and the host. Make sure the printer and the host flow
control settings match (both are DTR or both are
XON/XOFF). If the error persists, call Technical
Support.
8-16 Diagnostics and Errors