Final check – Paxton Superchargers Shelby Mustang GT User Manual

Page 57

P/N: 4809660

27FEB07 v1.0 05-07ShelbyMusGT(4809660v4.0)

13.

FINAL CHECK

If your vehicle has gone over 15,000 miles since
its last spark plug change, you will need to change
the spark plugs now before test driving the vehi-
cle.

Check all fittings, nuts, bolts and clamps for tight-
ness. Pay particular attention to oil and fuel lines
around moving parts, sharp edges and exhaust
system parts. Make sure all wires and lines are
properly secured with clamps or tie-wraps.

Check all fluid levels, making sure that your
tank(s) is/are filled with 91 octane or higher fuel
before commencing test drive.

Start the engine and allow to idle a few minutes,
then shut off.

WARNING: Do not attempt to operate the vehicle

until all components are installed and
all operations are completed including
the final check.

H.O Charge Cooled Kits Only

NOTE:

Check to see that CAC coolant is flowing
through the surge tank. If coolant is not
flowing, remove the 3/4" rubber hose
from the side of the surge tank and
apply light suction in an attempt to pass
any trapped air in the system. Reconnect
the hose and recheck coolant flow.

Recheck to be sure that no hoses, wires, etc. are
near exhaust headers or moving parts. Look also
for any signs of fluid leakage.

PLEASE TAKE SPECIAL NOTE:

Operating

the vehicle without ALL the subassemblies com-
pletely and properly installed may cause

FAIL-

URE OF MAJOR COMPONENTS.

Test drive the vehicle.

Always listen carefully for engine detonation.
Discontinue heavy throttle usage if detonation is
heard.

Read the

STREET SUPERCHARGER

SYSTEM OWNER'S MANUAL AND
RETURN THE WARRANTY REGISTRATION
FORM

within thirty (30) days of purchasing your

supercharger system to qualify.