Preparation/removal – Paxton Superchargers Shelby Mustang GT User Manual

Page 13

P/N: 4809660

27FEB07 v1.0 05-07ShelbyMusGT(4809660v4.0)

Disconnect the battery before proceeding.

Loosen the hose clamp at the throttle body.
Disconnect the plastic 3/8" tube assembly
attached to the passenger’s side valve cover.
Remove the plastic 3/8" x 90° connector from the
plastic tube that was connected at the passenger’s
side valve cover. Set this connector aside to be re-
used in a later step. Discard the remainder of the
hose assembly, as it will not be re-used. (See Fig.
1-c.)

Disconnect the mass air flow (MAF) sensor plug
and remove the inlet duct and upper air filter
cover from the car. (See Figs. 1-a, 1-b, 1-c.)

Remove the 10mm headed bolt (located next to
the inner fender) which secures the lower portion
of the air filter enclosure. Remove the lower por-
tion from the car - it will not be reused. (See Fig.
1-d.)

Remove the six plastic push pins securing the
radiator cover. Remove the cover and set aside to
be reinstalled later. (See Fig. 1-e.)

PREPARATION/REMOVAL

Fig. 1-a

Fig. 1-b

MAF CONNECTOR

Fig. 1-c

CRANKCASE

BREATHER HOSE

RETAIN THIS

90° HOSE END

Fig. 1-d

10mm HEADED BOLT

THROTTLE

BODY CLAMP

NOTE:

The preferred method of removing the
90° connector from its original plastic
tube is to apply a small amount of heat
to the tube and slide the connector free.