Paxton Superchargers Shelby Mustang GT - Manual (Page 34)

P/N: 4809660
©2007 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
27FEB07 v1.0 05-07ShelbyMusGT(4809660v4.0)
22
8. CHARGE AIR COOLER INSTALLATION cont’d
10. Locate assembly 8N104-125. Confirm that the
assembly is complete.
11. Attach the provided ring terminal to the
ground wire on the suplied water pump plug
harness. Connect the supplied length of 16GA
wire to the positive wire using the supplied
butt connector. Connect the water pump har-
ness to the water pump.
12. Locate the supplied water pump (8F001-403),
two 2-3/8" adel clamps, and water pump
mounting bracket. Place the adel clamps on
the water pump. Using the supplied 1/4-20
hardware, secure the water pump and clamps
to the mounting bracket. When installing,
attach the water pump ground wire to one of
the water pump mounting clamps using the
previously installed ring terminal. (See Fig.
8B-g.)
13. Attach the pump assembly to the two 8mm x
35mm long bolts previously installed and
secure using the 8mm nuts and washers pro-
vided. (See Fig. 8B-h.)
14. Route the positive wire up towards the dri-
ver’s side valve cover.
15. Locate the ballast resistor plug. Install the
supplied T-tap connector, cut the water pump
positive wire (from the water pump) for best
fit, attach the supplied male spayed connector
and attach to the wire T-tap connnector. (See
Fig., 8B-i.)
16. Cut the water pump positive wire and install
the inline fuse holder and fuse. Install the wire
loom provided and secure away from heat and
moving parts. (See Fig. 8B-i.)
Fig. 8B-g
Fig. 8B-h
MOUNTING BRACKET
ADEL CLAMP
PLUG HARNESS
WATER
PUMP
HOSE TO
PASSENGER’S
SIDE SHOCK
TOWER
8mm
HARDWARE
Fig. 8B-i
BALLAST
RESISTOR
POSITIVE WIRE
TO WATER PUMP
SUPPLIED
FUSE HOLDER
B. WATER COOLER ASSEMBLY
INSTALLATION, cont’d