Paxton Superchargers Shelby Mustang GT - Manual (Page 40)

P/N: 4809660
©2007 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
27FEB07 v1.0 05-07ShelbyMusGT(4809660v4.0)
28
Fig. 8C-d
Fig. 8C-e
10mm HEADED
BOLT
RESERVOIR
BRACKET
Fig. 8C-f
FACTORY
GROUND STRAP
3/4" HOSE ATTACHED
TO THERMOSTAT HOUSING
Fig. 8C-g
8. CHARGE AIR COOLER INSTALLATION cont’d
NOTE: Reinstall the factory ground wire
with one of the 6mm screws and
washers.
5. Remove the 10mm headed bolt that secures
the back of the ECU and the power distribu-
tion box. (See Fig. 8C-d.)
6. Install the coolant reservoir. Secure the front
of the reservoir with the factory fastener
removed previously. (See Fig.
8C-e.)
7. Attach the rear mounting bracket with the
surge tank mounting bracket to the strut tower
with the 6mm x 20mm long screws and wash-
er provided. (See Fig. 8C-f.)
NOTE: Leave this bolt loose for final adjust-
ment in a later step.
8. Attach a length of 3/4" hose (approximately 3'
long) to the 3/4" bung on the front of the
coolant reservoir. Route the hose to the 3/4"
outlet on the thermostat housing secure the
hose with the clamps provided. (See Fig. 8C-
g.)
C. ENGINE COOLANT RESERVOIR INSTAL-
LATION (2005-2006 Models Only), cont’d