Paxton Superchargers Shelby Mustang GT - Manual (Page 23)

P/N: 4809660
©2007 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
27FEB07 v1.0 05-07ShelbyMusGT(4809660v4.0)
11
M. Cut the remainder of the short 90° bend from the
factory radiator hose, approximately half way
between the 90° bend and the 45° bend, and dis-
card. (See Fig. 5.2-l.)
N. Using the 2.25" section of radiator hose cut previ-
ously and two #24 hose clamps provided, install
the short end of the 90° stainless tube (4FU014-
060) onto the repositioned thermostat housing.
(See Fig. 5.2-n.)
O. Install the remainder of the factory radiator hose
using one factory hose clamp and one #24 hose
clamp. (See Fig. 5.2-o.)
5.2 THERMOSTAT HOUSING/RADIATOR HOSE MODIFICATION
(2007 Model Year Only), cont’d
Fig. 5.2-l
END CONNECTED TO RADIATOR
CUT APPROX. 2.25"
AND SET ASIDE
90° BEND TO BE DISCARDED
Fig. 5.2-n
90° STAINLESS
TUBE (4FU014-060) 2.25" SECTION OF HOSE
PREVIOUSLY TRIMMED
#24 HOSE CLAMPS
Fig. 5.2-o
FACTORY
RADIATOR
HOSE
END OF HOSE
PREVIOUSLY
TRIMMED
#24 HOSE
CLAMP
FACTORY HOSE CLAMP
K. Locate the 4FU114-030 water pipe assembly.
L. Cut approximately 2.25" off the short 90° end of
the factory radiator hose and set aside. (See Fig.
5.2-l.)