Paxton Superchargers Shelby Mustang GT User Manual

Page 26

P/N: 4809660
©2007 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
27FEB07 v1.0 05-07ShelbyMusGT(4809660v4.0)

Fig. 6-f

Fig. 6-g

Fig. 6-h

Tighten all mounting plate hardware, making sure
the drive belt is properly routed and no wiring or
hoses are caught between the mounting surfaces.
(See Fig. 6-g.)

Install the five 3/8-16 x 1.0" bolts and washers
through the back side of the mounting plate. (See
Fig. 6-h.)

Attach the supplied length of 1/2" oil drain line
hose, and one #8 hose clamp from the previously
installed oil drain assembly, to the 1/2" barbed fit-
ting in the supercharger.

Install the supplied 1/8"NPT x -4 straight fitting
from assembly 4FU130-026 to the oil feed fitting
on the supercharger.

Attach the -4 oil feed hose to the straight -4 fitting
previously installed in the supercharger. Secure
away from moving or hot objects.

Using a 1/2" ratchet, rotate the factory spring ten-
sioner clockwise and install the accessory drive
belt. (Refer to Fig. 6-e for proper belt routing.)

SUPERCHARGER HARDWARE

.093"

SPACER

NOTE:

Any dips, “uphill” sections, kinks or
restrictions may cause drainage prob-
lems and possible supercharger failure.

Attach the supercharger assembly to the mounting
plate using the previously installed hardware. A
9/16" ratcheting end wrench will greatly aid in
this step.

Secure the oil drain hose to the prevously installed
brass fitting in the oil pan, making sure to route in
a smooth downward manner and away from mov-
ing or hot objects.

NOTE:

Use only clean engine oil on the pipe
threads. Teflon tape or pipe sealant is
not recommended as it might loosen
and cause blockage of the small oil feed
orifice resulting in possible supercharger
failure.

SUPERCHARGER MOUNTING PLATE INSTALLATION, cont’d