Supercharger mounting pla, Supercharger mounting plate installation – Paxton Superchargers Shelby Mustang GT User Manual

Page 24

The mounting plate is provided with the spacers
and bolts as they would be installed on the vehi-
cle. Keep these bolts and spacers marked as to
their locations. They are all different in size and
mismatching them will result is misalignment of
the mounting plate.

Locate the two supplied stud-bolt spacers (see
Figs. 6-b, 6-c) in the S/C mounting plate assem-
bly. Remove the factory screws retaining the idler
pulleys on the driver’s side of the engine and
replace with the stud spacers.

It is necessary to install the supercharger accesso-
ry drive belt and loosely route it following Fig. 6-
c, as not all pulleys are currently in place.

Locate the supercharger mounting plate 4FU010-
044 from the supercharger mounting plate assem-
bly. (See Fig. 6-a.)

Locate the two 8mm x 140mm long bolts and
washers from the mounting bracket assembly and
install in the locations noted. (See Fig.
6-a.)

Slide the two long spacers onto the bolts previous-
ly installed. (See Fig. 6-f.) Install the small trian-
gle-shaped idler pulley mounting bracket to the
spacers. Install the .093" spacer onto the bolt that
will be attached in the alternator location.

Lower the mounting plate assembly into position
on the front of the engine. Be sure to route the
drive belt on the correct side of the idler bracket
and spacers. (See Fig. 6-g.)

Loosely attach the plate using the previously
installed 140mm hardware. Locate the two 3/8-16
x 1.0" bolts and washers and install through the
plate into the two stud bolt spacers retaining the
factory idlers. (See Figs. 6-a, 6-c.)

Locate the 8mm x 150mm bolt and washer.
Loosely install the bolt through the mounting
plate and remaining long spacer into the engine
cover using Fig. 6-a for location reference.

Locate the supplied idler, 1.776" idler spacer, idler
pilot spacer, 3/8-16 x 3.75" long bolt and washer.
Install the bolt/washer through the mounting plate,
1.776" spacer, supplied idler, idler pilot spacer
and into the triangle-shaped bracket. (See Figs. 6-
f to 6-h for assistance.)

SUPERCHARGER MOUNTING PLATE INSTALLATION

Fig. 6-a

Fig. 6-b

Fig. 6-c

NOTE:

If installing a standard output kit (non-
cooled), the 3/8" x 3.75" bolt will be
installed in the upper hole location. H.O.
kits install in the lower hole.

2 x 8mm x

140mm SCREWS

8mm x 150mm SCREW

2 x 3/8-16 x 1.0" SCREWS

3/8-16 x 3.75" SCREW

H.O. KIT SCREW LOCATION

5 x 3/8-16

x 1.0" SCREWS

NOTE:

This figure is just for reference. The
small idler pulley mounting bracket
will need to be installed at the same
time as the supercharger (S/C)
Mounting Plate. (See Fig. 7-d.)

STUD BOLT

SPACERS

STUD

BOLT

SPACERS

INSTALLED

NON-COOLED KIT SCREW LOCATION