Paxton Superchargers Shelby Mustang GT - Manual (Page 47)

P/N: 4809660
©2007 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
27FEB07 v1.0 05-07ShelbyMusGT(4809660v4.0)
35
8. CHARGE AIR COOLER INSTALLATION cont’d
G. COOLANT RESERVOIR FILL
1. Check to make sure all previously installed
hose connections are secure.
2. Fill the engine cooling system through the
Paxton supplied coolant reservoir using the
factory coolant previously drained.
3. Locate the factory coolant reservoir cap
removed in section 1 and install it on the
Paxton supplied reservoir.
4. (2005-2006 Only) Once the coolant system is
filled and all trapped air expelled, install the
1/8"NPT plug provided in the previoisly
installed cross-over tube. Thread sealant
should be used.
5. CAC cooling system.
a. Temporarily remove the 3/4" hose
attached to the 3/4" x 90° fitting on the
CAC surge tank.
b. Cap the open end of the 3/4" x 90° fitting
using the provided vinyl cap.
c. Fill the CAC system using a 25%/75%
antifreeze/water mix. Using a funnel, fill
through the 3/4" hose removed from the
surge tank fitting.
d. Fill the system until the coolant level
reaches the surge tank.
e. Remove the vinyl cap from the surge
tank fitting and reinstall the 3/4" hose
previously removed and secure with the
nylon ratchet clamp.
6. Reinstall the front bumper assembly including
the foam inner bumper, all plastic splash pan-
els and light connections in the reverse order
removed.