Charge air cooler installation cont’d, Front of vehicle – Paxton Superchargers Shelby Mustang GT User Manual

Page 35

P/N: 4809660

27FEB07 v1.0 05-07ShelbyMusGT(4809660v4.0)

CHARGE AIR COOLER INSTALLATION cont’d

Fig. 8B-j | Viewed From Below

17.

Locate the 3/4" x 150° molded rubber hose
(7U038-150). Connect the short end of the
3/4" x 150° hose to the lower port on the pre-
viously installed water cooler. Install one of
the provided 3/4" hose unions into the open
end of the 150° hose. Attach a length of 3/4"
hose approximately 24" between tthe hose
union and the previously installed water pump
discharge. Secure all hose connections using
the nylon ratchet clamps provided. (See Fig.
8B-j.)

18.

Attach a length of 3/4" hose approximatelly
48" long to the previously installed water
pump feed port and secure. Route the open
end of the installed hose toward the passen-
ger’s side shock tower. This hose will be
connnected in later step. (See Fig. 8B-h.)

WATER COOLER

HOSE TO

WATER PUMP

3/4" x 150°

HOSE (7U038-150)

3/4" HOSE

UNION

FRONT OF VEHICLE

WATER COOLER ASSEMBLY
INSTALLATION, cont’d

NOTE:

The installation of this hose section
should maintain an “uphill” routing
wthout dips or kinks.