Paxton Superchargers Shelby Mustang GT - Manual (Page 44)

P/N: 4809660
©2007 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
27FEB07 v1.0 05-07ShelbyMusGT(4809660v4.0)
32
Fig. 8E-d
Fig. 8E-e
10mm HEADED
BOLT
RESERVOIR
BRACKET
Fig. 8E-f
3/4" HOSE ATTACHED
TO FACTORY 1" HOSE
Fig. 8E-g
8. CHARGE AIR COOLER INSTALLATION cont’d
5. Remove the 10mm headed bolt that secures
the back of the ECU and the power distribu-
tion box. (See Fig. 8E-d.)
6. Install the coolant reservoir. Secure the front
of the reservoir with the factory fastener
removed previously. (See Fig.
8E-e.)
7. Attach the rear mounting bracket with the
surge tank mounting bracket to the strut tower
using the factory strut mounting hardware.
(See Fig. 8E-f.)
8. Attach a length of 3/4" hose (approximately
22" long) to the 3/4" bung on the front of the
coolant reservoir. Secure using one of the #10
hose clamps provided. Route the open end of
the hose to the 1" hose previously connected
to the factory coolant reservoir. Connect and
secure the two hoses using the 3/4" x 1" hose
union, the factory 1" spring clamp and the #10
hose clamp provided.
NOTE: Leave this bolt loose for final adjust-
ment in a later step.
E. ENGINE COOLANT RESERVOIR INSTAL-
LATION (2007 Models Only), cont’d
SURGE TANK
RESERVOIR
BRACKET
COOLANT RESERVOIR