Paxton Superchargers Shelby Mustang GT - Manual (Page 32)

P/N: 4809660
©2007 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
27FEB07 v1.0 05-07ShelbyMusGT(4809660v4.0)
20
8. CHARGE AIR COOLER INSTALLATION cont’d
NOTE: Leave these screws loose for adjust-
ment when attaching the assembly
to the vehicle.
NOTE: Refer to Fig. 8B-q throughout the
following steps:
1. Locate the water cooler assembly 8N106-135.
2. Install the two mounting bracket 8N010-171
and 8N010-173 to the water cooler using the
supplied 1/4-20 x 1/2" screws, washers. (See
Fig. 8B-a.)
3. Remove four nylon push pins from the styro-
foam bumper support and set the support and
the pins aside to be reinstalled. (See Fig. 8B-
b.)
4. Remove six of the eight 13mm headed inset
bolts retaining the metal bumper support.
(See Fig. 8B-c.)
5. Replace the bolts previously removed with the
six 8mm x 1.25" x 35mm long bolts and
washers provided.
6. Install the four 2A017-036 spacers (two each
side) onto the bolts that will secure the water
cooler. (See Fig. 8B-d.)
B. WATER COOLER ASSEMBLY
INSTALLATION
NYLON PUSH PINS
13mm HEADED BOLTS
Fig. 8B-d
Fig. 8B-c
Fig. 8B-b
Fig. 8B-a
SPACERS PROVIDED