Junger Audio D*AP4 FLX / D*AP4 LM Edition - Manual (Page 68)

D*AP4
63
Setup GUI – EVENTS – Triggers – Configuration – Trigger Equation
To form a Trigger you may logically combine two trigger sources below.
Trigger Here you define a label for the trigger (System Alarm).
Source 1 The first source of a logical combination of two trigger sources.
Invert [ON / OFF]
If the type of trigger allows an inverted operation it can be defined here.
Type [GPI / Hot Key, Network / Parameter / Event active / Trigger effective/
Bypass / Sync Lock]
Source
[e.g. for GPIs it will be 1 … 8]
It acts like an index for the respective trigger type (in case of GPIs
it is the physical GPI number or in case of X*AP Hotkeys the key
number (1 of 8).
Logic Kind of logical operation [and, or, xor].
Source 2 Second source for the logical combination of two trigger sources.
If only one source exists, you may leave it unassigned [-].
Above we have defined two triggers:
"System Alarm" that becomes active if parameter trigger 1 = "Sync Alarm" or
parameter trigger 2 = "SDI Alarm" become active.
"Automation 1" becomes active if the automation activates the first network trigger "Soft GPI-1"
or if one presses the first hotkey of the X*AP RM
1 .
Now since we have prepared the ignition, we must load the bombs …
I.e. we define what will happen if … so we must define the events.