D*ap4 – Junger Audio D*AP4 FLX / D*AP4 LM Edition User Manual
Page 50

D*AP4
45
Band 1 … 5
[OFF / Peak 1 / Peak 2 / Lo Shelf / Hi Shelf / Lo Cut / Hi Cut]
Filter characteristic will be selected by this pop-up:
Link
[Unlinked, Linked]
For stereo operation you may link the
setup parameters
Equalizer
[ON / OFF]
Band 1
Filter Type
[OFF / Peak 1 / Peak 2 / Lo Shelf / Hi
Shelf / Lo Cut / Hi Cut]
Frequency (Hz)
[20 … 20000]
Gain (dB)
[-20.0 … 20.0]
Q
[0.4 … 4.0]
Band 2 … 5
similar parameters as Band 1
The EQs offer two different peak modes:
Peak 1: The bell curves of the Peak 1 filter features constant quality (Q) over gain.
Q is defined at -3 dB below peak. It does not change when altering gain.
Peak2: The bell curves of the Peak 2 filter also features constant quality (Q) over gain.
But Q is defined at 50 % of gain. Subjectively the bell curve becomes sharper when
increasing gain, but this is only true for the lower 6-8 dB of gain.