Junger Audio D*AP4 FLX / D*AP4 LM Edition - Manual (Page 23)

D*AP4
18
Setup GUI – SYSTEM - the preset concept in detail
The example above shows the preset concept of the D*AP4. It is a general feature of the device and you will
come across it in almost every area. For all relevant settings one set of ON AIR parameters and a practically
unlimited number of PRESETS are available. The count depends on the NV memory space left.
If you want to load parameters from a preset to the ON AIR area or save parameters from the ON AIR area
to a preset, you must press
or :
A dialog opens to select the desired preset. When you press the selected action will be executed.
When you press on the little pencil icon the preset name turns italic and you may edit it.
To generate a new preset offline, you must click into the preset name field below the PRESET headline:
The pull down offers "Add Preset". If you select this a new entry to the list will be
generated. Clicking on the small trash bin symbol will delete that preset.
You may change the default name "Preset x" by clicking on the small pencil icon.
Now the default name becomes italic and you may edit that name.
If you have selected the new preset or one of the existing presets indicated by the name displayed at the
top, you may edit the parameter values.
Important Note! The presets of the D*AP4 are persistent by nature. You are working directly on the preset
memory, i.e. you need not worry about storing such presets. The D*AP4 does it for you.
On the other hand you must be aware that you overwrite the actual preset settings! If you want to keep
original values (e.g. from a factory preset) you must simply copy the content of an existing one to the clip
board, add a new preset, name it differently and paste the clip board to it.
At the bottom of the PRESET part you find the soft buttons to the content of that preset to the clip
board or to the content of the clip board into an other preset which you have selected before
pasting.
You may also or the preset content to / from a file.
Setup GUI – SYSTEM – SNMP
This pane is meant for basic settings of the SNMP Agent of the device. If you are not familiar with the use of
SNMP protocol for system monitoring you should not enable the SNMP agent.