Junger Audio D*AP4 FLX / D*AP4 LM Edition - Manual (Page 45)

D*AP4
40
The Phase Rotator detects this type of imbalance
and automatically applies a complex
phase wrapping filter to restore symmetry.
Please keep in mind that this system is not
effective against DC offset. In this case
a high pass filter should be applied instead.
Setup GUI – AUDIO PROCESSOR – Fail Over
Fail Over 1L/1R The D*AP4 offers a fail over circuit
for automatic operation.
MODE [FIX 1L/1R / FIX 2L/2R / AUTO]
In AUTO mode the switch over
happens in case of an input failure.
Fail Threshold (dBFS) [-80 … -60 … -40]
RMS weighted input level for fail
detection.
Fail Wait (s) [1.5 … 10.0]
elapsed time after fail detection until
the switch over will happen.
Fail Return (s) [0.0 … 10.0]
elapsed time after detection of a
proper input signal until the switch
back to the program input.
Side Chain Filter [OFF / ON]
a high pass filter (300 Hz) and a low
pass filter (3000 Hz) is applied to
the detector side chain (not the
audio path) to prevent hum and
noise from blocking fail over
switching.
Setup GUI – AUDIO PROCESSOR – De-Esser
Link [Unlinked, Linked]
For stereo operation you may link
the setup parameters for both
voice channels.
De-Esser [ON / OFF]
Frequency (Hz) [1000 … 3000 … 16000]
Range (dB) [-20.0 … 0.0]
Filter Type [Peak / High Shelf]
Q [0.4 … 1.0 … 8.0]
Side Chain [OFF / active]
Listen