beautypg.com

D*ap4 – Junger Audio D*AP4 FLX / D*AP4 LM Edition User Manual

Page 26

background image

D*AP4

21


Setup GUI – INTERFACES – AES I/O

Status

[green / red / yellow] The soft LED represents the status

Input Signal Status

[OK / Fail]

Fail = no carrier, unlock, cranky [too much jitter]

Input Signal Type

[Mute / PCM / Non PCM]

The Non PCM (e.g. Dolby encoded signal) status will be retrieved
from a logical combination of the Validity flag and the channel
status.

If one of the inputs is not assigned by the ROUTING section, its
status will not be incorporated into the System Status (see upper left
hand side above).

Settings

Enable Relay Bypass

[ON / OFF]

For fail save operation bypass relays are provided to connect
AES IN / OUT in case of a power fail. One may enable such relay
manually here.

Input Sample Rate

[ON / OFF]

Converter

For asynchronous sources it is possible to turn a SRC on.
If an SRC is turned on and the input status becomes Non-PCM, the
SCR will be turned OFF automatically in order to maintain the
original data structure of the encoded bit stream (e.g. Dolby E).

Output Channel

[Transparent / Prof PCM / Prof Non-PCM / Cons PCM /

Status

Cons Non-PCM]

The channel status can either be transparent from the
input source of the D*AP4 or may be overwritten.

Input Source Select

[BNC / XLR]

You must select here which input is in use.
(AES3id = BNC or AES3 = XLR).

This manual is related to the following products: