D*ap4, Operating manual, Audio o – Junger Audio D*AP4 FLX / D*AP4 LM Edition User Manual
Page 5
DAP4-MEI_manual_EN_150327.doc
D*AP4
Hardware Features
•
1RU
compact 19" processing device with front side info display
• Dual power supply
second power supply for redundancy
• Front panel info display
for signal activity, IP address, QR code, status alert
• Two hidden touch buttons
to change the content of the info display
•
Remote Panel
optional X*AP RM
1
panel
• Audio inputs
balance/unbalanced AES – manual selection
•
Audio o
utputs
balance/unbalanced AES
• One interface slot
I/O expansion slot for one option board at a time
• 3G / HD / SD SDI
SDI de-embedder / embedder - power fail relay bypass
• 4x AES I/O module
4x AES3id I/Os – power fail relay bypass
• 4Ch analog I/O module
4 analog line I/Os – power fail relay bypass
• RJ45 network connector
100BaseT full duplex Ethernet interface
• USB B connector
built in USB < > serial adapter to access the device service port
• 8 GPI/Os
8 balanced inputs, 8 relay closure combined on a 25pin D-Sub
•
Aux power supply
isolated 5V supply for external wiring
•
External sync IN
75Ohm input (Word Clock, AES, Black Burst, Tri-Level)
•
Sync OUT
75Ohm Word Clock output
Software Features in general
The D*AP4 may be purchased as a Level Magic Edition and will appear as D*AP4 LM or based on the
software licenses of the FLX concept. In this case it appears as D*AP4 FLX.
Pls. contact your local dealer for details.
• LevelMagic II™
loudness management according to ITU BS.1770-1/-2/-3
EBU R128, ATSC A/85, ARIB TR-B32, Free TV OP-59, Portaria 354
• Dynamic filter
optional SPECTRAL SIGNATURE™ dynamic EQ
• EQ
optional 5 band parametric
•
Dynamics
optional compressor, expander / gate
• Fail over
optional automatic switch over with signal loss detection
• Voice over
optional stereo or mono voice over extra program input, pan
• FM Conditioner
optional MPX limiter and Pre-Emphasis
• Loudness measurement
in reference to the selected standard
•
SNMP agent
SNMP v1, see D*AP4-MIB
• Remote control
l-s-b EmBER plus protocol or X*AP RM1 remote panel
and legacy GPI/Os
Operating Manual