Drylam Fujipla ALM3222 User Manual
Page 59
AL-MEISTER ALM3222 Instruction Manual
Page 59 of 63
●”FEEDING ERROR”
No paper on the tray to feed.
This error is often caused by SET
COUNT set to “FREE” and no paper
on the tray. Press RESET to clear the
error, place paper on the tray and try
again. To eliminate this each time
the tray runs out go into MODE | SET
COUNT and set this number less than
or equal to the number of sheets
placed on the tray.
Paper is thick and smooth on its
surface. The rollers cannot ‘grab’
the paper. Less than 2” of paper
is being pulled before this error
occurs.
Remove the paper. Slightly lower the
position of Paper Feed Resist Roller
Pressure Adjust about 1/8”, or one
mark on the label. See section
12. PAPER FEED RESIST ROLLER
PRESSURE ADJUSTMENT
(MECHANICAL)
Ruffle the sheets on
the tray. Press RESET button to clear
error and start again.
Paper guides are restricting the
movement of paper.
Widen Paper Guides about 1/16”.
Press RESET button to clear error and
try again.
The surface of Feeding Rollers is
not clean.
Remove paper. Open Feeder Cover.
Wipe off the stains on the Feed
Roller with soft cloth. Press RESET
button to clear error.
Paper is stuck between feeding
section and lamination section.
Open Feeder Cover. Remove all the
stuck paper. Press RESET button to
clear error. CAUTION: The lamination
rollers get very hot.
●”PAPER JAM”
Do not confuse with “PAPER
STUCK”
Film/paper is stuck at Cutter
section or Trimmer section.
Follow the instructions for the
problem. Laminated sheet is not
discharged.
Paper is longer than 20” (see
section)
Use shorter paper or, place ALM3222
into “LONG MODE” to laminate
longer sheets.
Paper is within spec length but, a
second sheet of paper has been
pulled in underneath the first
sheet of paper that the error
occurred on. The second sheet of
paper is blocking the feeder
sensor.
Reset the stack of paper on the
feeder tray. Press RESET to clear the
error and start again. Make a small
upward adjustment to the Paper
Feed Resist Roller Pressure adjust
knob (see
RESIST ROLLER PRESSURE
ADJUSTMENT (MECHANICAL)
Double cutting, too?
Check Cutter sensor- should be at
~330-400 (unthreaded, cutter
installed) and ~265-275 (Cutter Unit
removed). Threshold at 48. If cutter
installed value is lower than cutter
removed value, check film guides on
Cutter Unit.
●”DISCHARGE ERROR”
Film and/or paper is emerging
Before pressing START use the CUT