5. eco mode (power saving mode), 6.terminate lamination, Automatic operation (cont’d) – Drylam Fujipla ALM3222 User Manual

Page 56

Text mode
Original mode

AL-MEISTER ALM3222 Instruction Manual

Page 56 of 63

5. AUTOMATIC OPERATION (cont’d)

5-5. ECO MODE (Power Saving Mode)

ECO MODE enters when the machine is idle and any
buttons on the operation panel* have not been
pressed in the past 15 minutes.

*This does not apply to the “MOVE” switch.

A buzzer will sound 1 minute before entering ECO MODE. ECO MODE will be deactivated by pressing any
button, the 15 minute timer then starts again.

1) Current temperature.
2) ECO MODE temperature goal (140F).

5-6.TERMINATE LAMINATION

1. Make sure the lamination has finished.
2. Turn off Power Switch.
3. Disconnect the power plug.