Drylam Fujipla ALM3222 - Manual (Page 49)

AL-MEISTER ALM3222 Instruction Manual
Page 49 of 63
5. AUTOMATIC OPERATION (cont’d)
5-2-11. CHECK FILM INFO
1. Press MODE and use the cursor buttons to select FILM INFO. Press MODE again.
---- FILM INFO ----
A
38mic. 320mm
LEFT: 80%
This display appears along with the following information:

Film thickness

Film width

Remaining film
If film information is not available the display shows “xxx” rather than numerals:
---- FILM INFO ----
x
xxmic. xxxmm
LEFT: xxx%
This will be the case when a valid RFID tag in not in its proper position or an invalid tag is used. See
section 4 for more information on RFID tags.