Drylam Fujipla ALM3222 - Manual (Page 47)

AL-MEISTER ALM3222 Instruction Manual
Page 47 of 63
5. AUTOMATIC OPERATION (cont’d)
5-2-9. PAPER FEED ADJUST (SOFTWARE)
PAPER FEED ADJUST is a parameter that adjusts the aggressiveness of the feeding section to enhance
compatibility of varying paper stocks. This should be utilized in conjunction with the Paper Feed Resist
Roller Pressure Adjust (MECHANICAL) knob under the Feed Tray (see
section 5-2-11 ).
1. Press MODE and use the arrow buttons to select PAPER FEED ADJUST parameter. Press MODE again.
---- PAPER FEED ADJUST ----
VALUE: 10
2. Adjust the value using the up and down arrows. The factory default is 0. The range is:
Ver 2.2 and prior +10 to -10 in increments of 1
Ver 3 +20 to -20 in increments of 1
If paper/toner is difficult to separate and feed use a more positive (higher) value. This will run the feeder
a longer amount of time after the leading edge of paper has passed the Feeder Sensor. Use a more
positive value in cases where paper does not reach the film in time (and “LAMINATION ERROR” errors
result).
If paper is very easy to separate and feed use a more negative (lower) value. This will make the Feeder
less aggressive. A lower value should be used if:

Certain lamination defects occur including, but not limited to, jamming of the leading edge of
paper occurs at the film. This might be seen as any, or part of the leading edge of a sheet paper
folded over within the film.

Frequent “PAPER JAM” errors occur.

Skewing of paper is observed occurring on the paper tray.