Drylam Fujipla ALM3222 - Manual (Page 44)

AL-MEISTER ALM3222 Instruction Manual
Page 44 of 63
5. AUTOMATIC OPERATION (cont’d)
5-2-7. CUT ADJUST
This function adjusts the cutting positions at both the leading, and trailing edges of the paper.
NOTE: These settings are retained in memory after a power outage.
NOTE: These settings only affect the leading and trailing edge cuts. They do not affect the side cuts
made by the Trimmer Unit.
NOTE: It is recommended to read and record the present values shown on the display before adjusting.
It may be helpful if it is necessary to set back to a past value.
NOTE: Each ALM3222 has its own Cut Adjust values. The numbers seen are relative only to this
particular machine and not to anything in the “real world”.
1. Select Cut Adjust from the Mode display.
---- CUT ADJUST ----
>F: 0.012inch
B:-0.004inch
2. Press TEMP/SPEED button to toggle between F and B.
F: cutting position at the front end (leading edge)
B: cutting position at the back end (trailing edge)
Do nothing to return to the operation screen.
3. Or, set one or both values using the UP/Down buttons. On versions
prior to 2.2 adjustment can be done between:
F and B: - 0.400" to + 0.400"
On ver 2.2 and ver 3 adjustment can be done between:
F: -.200 to 1.200
B: -1.200 to +.200
Do nothing to retain the settings and return to the operation menu.