Drylam Fujipla ALM3222 - Manual (Page 40)

AL-MEISTER ALM3222 Instruction Manual
Page 40 of 63
5. AUTOMATIC OPERATION (cont’d)
[CUT ADJUST]
Adjusts the cutting positions of the leading and trailing edges of sheets. See
section 5-2-7.
NOTE: These settings are retained in memory after a power outage.
[FINE MODE]
Hides any “dwell line” that may be present. See
section 5-2-8.
NOTE: This setting is retained in memory after a power outage.
[PAPER FEED ADJUST]
Works in conjunction with the Paper Feed Resist Roller Pressure Adjust knob (see
section 5-2-12 ) to
provide compatibility for difficult to feed paper stocks and toner. See section 5-2-9.
NOTE: This setting is retained in memory after a power outage.
[TOTAL COUNT]
Total Count indicates the accumulated number of laminations since the RESET button was pushed.
NOTE: This number is retained in memory after a power outage. See
section 5-2-10.
[FILM INFO]
Displays information about the film currently in the machine. See
section 5-2-11.
NOTE: Information only- nothing to retain.