Drylam Fujipla ALM3222 - Manual (Page 16)

AL-MEISTER ALM3222 Instruction Manual
Page 16 of 63
2. NAMES AND FUNCTIONS (cont’d)
2-5. OTHER SWITCHES AND BUTTONS
Open the trimmer cover.
1) Manual MOVE Switch
Use to set/feed film or to take out paper when it is stuck
To feed forward, turn the switch to left.
To feed backward, turn the switch to right.
* Set the trimmer adjuster to Film Set position during the threading process.
The MOVE switch will not operate after some errors (see troubleshooting chapter on
page 47).
2) Manual CUT Switch
Use when setting film or cutting film which is stuck in the laminator. It only works once.
*It does not work when a cutting error has occurred.
NOTE: The manual MOVE switch works most any time in manual mode, except after some errors. After some
errors it may be necessary to press RESET to clear the error which will restore the MOVE switch.
CAUTION: Whenever using the MOVE switch it is important to account for all film going into the machine,
particularly during the threading process. If film does not exit the discharge in less than 5 seconds
STOP! Film
may be accumulating within the machine. If this is allowed to continue, damage to interior components of the
machine will occur.
*If you believe an excess amount of film has gone into the machine release the MOVE switch. Raise the
Lamination Handle and pull the film back out the front of the lamination area. Use the MOVE switch to assist,
if necessary.
*Whenever you use the manual MOVE Switch, even for a brief moment, always move enough film out the
discharge to grab on to. Then, always cut the film by using the manual CUT button and pull the cut film/paper
from the discharge. This must be performed before pressing the START button, otherwise errors and/or
damage to the machine may result.