Drylam Fujipla ALM3222 - Manual (Page 22)

AL-MEISTER ALM3222 Instruction Manual
Page 22 of 63
4. SET LAMINATION FILM/MANUAL MODE (cont’d)
NOTE: If the film roll(s) are incorrectly loaded adhesive may contact the heat rollers or other interior
components and cause damage.
5. Remove the lower Film Guide Bar. Push the bar to one
side to compress the spring and pull the other end out
of the machine.
6. The lower film roll contains an RFID tag in the left end of the core. Handle this roll carefully! This tag is a
printed label adhered to a cap and placed in the end of the core. This cap/tag must be placed carefully towards
the non-operator side of the machine.
NOTE: RFID tag location for lower roll