Drylam Fujipla ALM3222 - Manual (Page 24)

AL-MEISTER ALM3222 Instruction Manual
Page 24 of 63
4. SET LAMINATION FILM/MANUAL MODE (cont’d)
8. Raise the Lamination Handle to the OPEN position to separate the heat and pull rollers for threading.
9. Pull the upper film off the roll. Pull it down and
over the upper rotating idler bar. Bring the end of the film down until it just touches the lower film. This
should overlap both heat rollers by a few inches.
10. Bring the lower sheet of film up and over the upper sheet of film. There should now be two sheets of film
crossing the heat rollers and overlapping each other by about 6-8”.