Drylam Fujipla ALM3222 - Manual (Page 46)

AL-MEISTER ALM3222 Instruction Manual
Page 46 of 63
5. AUTOMATIC OPERATION (cont’d)
5-2-8. FINE MODE ADJUST
When enabled and set to one of three setting FINE MODE addresses the “dwell line” which can be an
issue with certain combinations or paper, print, speed and temperature. “Fine Mode” attempts to
“hide” the dwell line making it less noticeable. For fastest speed leave FINE MODE in the “OFF” position.
1. Press MODE and use the cursor buttons to select FINE MODE. Press MODE again.
---- FINE MODE ----
TIME: 10 ms
2. Select the setting by again moving the cursor. The processing volume and finishing quality are shown
in the table below.
FINE
Processing
Volume
Reduction of
Dwell Line
OFF 4 1
F10 3 1
F20 2 2
F30 1 3